BNRLD - BATTERY FLUID, ACID CORROSIVE MATERIAL, UN2

  • MSDS: BNRLD
  • Manufacturer: EAST PENN MANUFACTURING CO INC
  • Product Name: BATTERY FLUID, ACID CORROSIVE MATERIAL, UN2
  • National Stock Number: 6140-01-300-4836
Product Identification

Product ID:BATTERY FLUID, ACID CORROSIVE MATERIAL, UN2
MSDS Date:11/09/1990
FSC:6140
NIIN:01-300-4836
MSDS Number: BNRLD

Responsible Party
EAST PENN MANUFACTURING CO., INC.
DEKA ROAD
LYON STATION, PA 19536
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 215-682-6361

Cage: DO231

Contractor
NORTHWESTERN MOTOR CO INC
265 EAU CLAIRE, WI 54702 US

Telephone: 715-835-3151

Cage: 44185

Ingredients

SULFURIC ACID (SARA III)

CAS: 7664-93-9

RTECS: WS5600000

Fraction By Weight: 30 - 38%

OSHA PEL 1 MG/M3

ACGIH TLV: 1 MG/M3; 9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Hazards

LD50 LC50 Mixture:ORAL LD50 (RAT) IS UNKNOWN.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SHORT TERM EXPOSURE: SULFURIC ACID MAY
CAUSE IRRITATION OF EYES, NOSE & THROAT. PROLONGED CONTACT MAY
CAUSE SEVERE BURNS. LONG TERM EXPOSURE: REPEATED CONTACT CAUSES
IRRITATION & SKIN BURNS. REPEATED EXPOSURE TO MIST MAY CAUSE
EROSION OF TEETH, CHRONIC EYE IRRITATION & INFLAMMATION OF THE
NOSE, THROAT & BRONCHIAL TUBES
Explanation of Carcinogenicity:THIS PRODUCT IS NOT LISTED BY IARC, NTP
OR OSHA AS A CARCINOGEN, MUTAGEN, TERATOGEN OR NEUROTOXIN.
Effects of Overexposure:ACID CONTACT MAY CAUSE IRRITATION OF EYES, NOSE
AND THROAT. BREATHING OF MIST MAY PRODUCE RESPIRATORY DIFFICULTY.
CONTACT WITH EYES AND SKIN CAUSES IRRITATION AND BURNS. SULFURIC
ACID IS A CORROSIVE C HEMICAL.
Medical Cond Aggravated by Exposure:PULMONARY EDEMA, BRONCHITIS,
EMPHYSEMA, DENTAL EROSION AND TRACHEOBRONCHITIS.

First Aid

First Aid:EYES: IMMEDIATELY FLUSH WITH RUNNING WATER FOR 15 MINUTES
WHILE HOLDING EYELIDS OPEN. GET IMMEDIATE MEDICAL ATTENTION. SKIN:
FLUSH WITH RUNNING WATER WHILE REMOVING CONTAMINATED CLOTHING AND
SHOES. GE T MEDICAL ATTENTION. INHALATION: REMOVETO FRESH AIR. IF
NOT BREATHING, GIVE ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION.
INGESTION: DO NOT INDUCE VOMITING. GET IMMEDIATE MEDICAL ATTENTION.

Fire Fighting

Flash Point:NON-FLAMMABLE
Extinguishing Media:USE MEDIA SUITABLE FOR SURROUNDING FIRE.
Fire Fighting Procedures:SULFURIC ACID WILL NOT BURN BUT IS CAPABLE OF
IGNITING FINELY DIVIDED COMBUSTIBLE MATERIAL ON CONTACT.
COMBUSTIBLES MAY BE SMOTHERED BY DRY CHEMICAL MEDIA.
Unusual Fire/Explosion Hazard:NFPA RATING: H=3, R=0, F=2.

Accidental Release

Spill Release Procedures:DILUTE SPILL CAUTIOUSLY WITH FIVE TO SIX
VOLUMES OF WATER & GRADUALLY NEUTRALIZE WITH SODIUM BICARBONATE,
SODA ASH OR LIME. WHEN EXPOSURE LEVEL IS NOT KNOWN, WEAR NIOSH/MSHA
APPROVED POSITIVE PRESSURE SELF-CONTAINED RESPIRATOR.
Neutralizing Agent:SODIUM BICARBONATE, SODA ASH OR LIME.

Handling

Handling and Storage Precautions:STORE AWAY FROM REACTIVE MATERIAL AS
DEFINED IN REACTIVITY DATA.
Other Precautions:SODIUM BICARBONATE, SODA ASH, SAND OR LIME SHOULD BE
KEPT IN SAME GENRAL AREA FOR EMERGENCY USE.

Exposure Controls

Respiratory Protection:NIOSH/MSHA APPROVED ACID GAS RESPIRATOR REQUIRED
WHEN PEL IS EXCEEDED OR EMPLOYEE WITNESSES RESPIRATORY IRRITATION.
Ventilation:ADEQUATE VENTILATION TO MAINTAIN EXPOSURE BELOW PEL. LOCAL
EXHAUST IS PREFERRED WHEN PEL IS EXCEEDED.
Protective Gloves:ACID RESISTANT (RUBBER GLOVES).
Eye Protection:CHEMICAL SAFETY GOGGLES W/FACE SHIELD.
Other Protective Equipment:ACID-RESISTANT APRONS, BOOTS & PROTECTIVE
CLOTHING.
Work Hygienic Practices:GOOD PERSONAL HYGIENE AND WORK PRACTICES ARE
MANDATORY.
Supplemental Safety and Health
THIS NSN IS FOR AN ACID LEAD STORAGE BATTERY. (SEE P/N IND B FOR MSDS).
THIS MSDS IS FOR ONLY THE ELECTROLYTE USED INSIDE THE BATTERY.

Chemical Properties

HCC:C1
Boiling Pt:B.P. Text:235F,113C
Vapor Pres:13
Spec Gravity:1.220 - 1.325
pH:1
Evaporation Rate & Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:COMPLETE
Appearance and Odor:CLEAR, ODORLESS, COLORLESS LIQUID.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ALKALI MATERIALS, CARBIDES, CHLORATES, NITRATES AND PIERATES,
ORGANIC ACID, ACETATES, ANHYDRIDES.
Stability Condition to Avoid:CONTACT WITH METAL MAY RELEASE EXPLOSIVE
HYDROGEN GAS.
Hazardous Decomposition Products:THERMAL DECOMPOSITION OR COMBUSTION
MAY PRODUCE A SULFUR TRIOXIDE AND/OR SULFUR DIOXIDE.

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.